Denon AVR-3805 - Manual (Page 36)

36
8 Enter the setting.
The “Channel Level” screen reappears.
To cancel the settings, press the CURSOR down to select “Level Clear” and “Yes” on the “Channel Level” screen, then make the settings
again.
The level of each channel should be adjusted to 75 dB (C-weighted, slow meter mode) on a sound level meter at the listening position.
If a sound level meter is not available adjust the channels by ear so the sound levels are the same. Because adjusting the subwoofer level test
tone by ear is difficult, use a well known music selection and adjust for natural balance.
NOTE:
When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer’s own volume control.
When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect
all surround modes. Consider this mode a Master Channel Level adjustment mode.
After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and
adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode,
your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each
surround mode. (See page 72)
You can adjust the channel levels for each of the following surround modes: PURE DIRECT/DIRECT, STEREO, DOLBY/DTS SURROUND,
5/7 CH STEREO, WIDE SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB, CLASSIC CONCERT, MONO MOVIE, VIDEO GAME,
MATRIX and VIRTUAL.
When using either surround speakers A or B, or when using surround speakers A and B at the same time, be sure to adjust the balance of
playback levels between each channel for the various selections of “A or B” and “A and B”.
CH SEL
ENTER
CH SEL
ENTER
(Main unit) (Remote control unit)
2-4 Setting the crossover frequency
1 Select the “Crossover Frequency” at the Speaker
Setup Menu.
• Set the crossover frequency mode according to the speaker system being used.
Select the frequency.
CH SEL
ENTER
(Main unit) (Remote control unit)
CH SEL
ENTER
CH SEL
ENTER
(Main unit) (Remote control unit)
CH SEL
ENTER
C r o s s o v e r F r e q .
* S p e a k e r S e t u p
4 Enter the setting.
The Speaker Setup Menu reappears.
CH SEL
ENTER
CH SEL
ENTER
(Main unit) (Remote control unit)
3
2 Display the Crossover Frequency screen.
CH SEL
ENTER
CH SEL
ENTER
(Main unit) (Remote control unit)
8 0 H z
* C r o s s o v e r F r e q
• 40 / 60 / 80 / 100 / 120 / 150 / 200 / 250 Hz can be
selected.