TrakPower Temperature Gauge with Stopwatch - Manual (Page 3)

3
Auto - Off Feature
1. The temperature gauge will shut off automatically after
approximately 15 seconds of inactivity.
2. In stopwatch mode, the unit will shut off after approximately
15 seconds of inactivity if the stopwatch has not started
timing. It will shut off after approximately 45 seconds of
inactivity IF the stopwatch has been started AND then is
paused – OR – if the stopwatch has been running and was
reset to 00:00.
Battery Level Indicator
Indicates
full battery
level.
Indicates
partial battery
level.
Indicates
low battery level
and battery will need
to be replaced.
Error Messages
The ITG incorporates the following visual diagnostic error
messages:
“Hi” or “Lo” is displayed when the temperature being measured
is outside of the range of the instrument, “Hi” when higher than
+428ºF (+220ºC) and “Lo” when lower than –27ºF (–33ºC).
“Er2” is displayed when the temperature gauge is exposed to
rapid changes in the ambient temperature.
“Er3” is displayed when the ambient temperature of the
temperature gauge EXCEEDS +14ºF (–10ºC) OR +122ºF
(+50ºC). In both cases you should allow plenty of time
(minimum 30 minutes) for the thermometer to stabilize to
the working/room temperature.
For all other error messages it is necessary to reset the
temperature gauge. To reset, wait for the instrument to power
off, remove the battery and wait for a minimum of one minute,
then reinsert the battery and turn on. If the error message
remains, please contact Hobby Services for further assistance.
Replacing the Battery
1. The unit must be turned off before replacing battery
or a malfunction could occur.
2. Remove the belt clip on the rear of the gauge by
removing the screw and pulling the clip straight off.
3. Twist the battery door clockwise approximately 1/8th
turn and remove door.
4. Carefully remove battery.
5. Replace battery only with a 3 volt CR2032 lithium cell,
which is readily available at many local retailers.
Storage & Cleaning
The thermometer should be stored at –4º to 149ºF (–20º to
+65ºC). The sensor is the most delicate part of the thermometer
and should be kept clean at all times. Care should be taken
when cleaning the lens. Use only a soft cotton swab with
water or medical alcohol, and allow the lens to fully dry before
using the thermometer. Do not submerge any part of the unit
in water or other liquid.
1-Year Limited Warranty
TrakPower warrants this product to be free from defects in
materials and workmanship for a period of one (1) year from
the date of purchase. During that period, we will repair or
replace, at our option, any product that does not meet these
standards. You will be required to provide proof of purchase
date (invoice or receipt). If during the one year period, your
TrakPower product shows defects caused by abuse, misuse,
alteration or accident, it will be repaired or replaced at our