beautypg.com

TrakPower 12V DC Nitro Engine Heater User Manual

Introduction, Specifications, Special features

background image

INTRODUCTION

The TrakPower engine heater uses technology similar to

that used by Formula 1, Indy Car and NASCAR teams. It
will properly pre-heat your engine to 140-158˚F (60-70˚C)
in 10 minutes based on ambient temperatures.

The TrakPower Engine Heater will pre-heat all critical parts

of your nitro engine, giving you minimal stress and wear on
the engine. It helps relieve stress on the crankshaft, con-
rod, piston and sleeve during warm-up. It also gives you a
very easy and smooth engine start, with no stress on your
starterbox. Fuel consumption is much less, as you do not
have to spend time warming up and adjusting your engine.

A pre-heated glow plug will increase the life of your plug. It

is also perfect for break-in, as it reduces the “pinch” on your
new engine. You will experience that engine pre-heating
is a must. Most importantly, it will quickly pay for itself by
increasing engine life and performance!

SPECIFICATIONS

Input

Voltage

12VDC

(12VDC power supply or 3S LiPo)

Heating

Power

90W

Heating

Time

10

minutes

Low Voltage Cutoff 9.0V (3.0V per cell)
LED

Indicator

Heating:

Solid blue LED

Low Voltage Cutoff:

Flashing blue LED

Weight

65g

Dimensions

Diameter: 63mm

Height: 50mm

SPECIAL FEATURES

● MCU control heating time and heating power for

maximum safety

● Safety timer: turn off power around 10 minutes

automatically

● LED indicator for status of engine heater
● 12V DC source with low voltage cutoff
● Fireproof and heat resistant adjustable cover
● Fits all .19-.26 RC nitro engines

● Very small, lightweight and compact for quick and

easy storage

● It is designed to transfer heat effectively and

effi ciently

● Access port on top allows you to start and monitor

your engines temperatures without having to
remove the heater

HOW TO USE

1. Place the engine heater over the cylinder head.

2. Connect the power cord to a DC power source or 3S

LiPo battery.

3. Push white power button. The LED will turn blue and

the engine heater will begin heating the engine for 10
minutes. If the desired temperature is not reached within

10 minutes, push the power button again to heat for an

additional 10 minutes.

4. To turn off the heater during the heating process, push

and hold the power button for more than 3 seconds and
the heater will stop.

5. Disconnect the DC power source and remove the heater

from the engine. CAUTION: The heater and engine will
be HOT.

6. Now you are ready to start your pre-heated engine.

WARNING: NEVER APPLY POWER TO THE

ENGINE HEATER IF IT IS NOT MOUNTED ON

AN ENGINE. IT WILL OVERHEAT AND POTENTIALLY

DAMAGE THE ENGINE HEATER.

SAFETY NOTES

● Before using every time be sure the heater element,

cord, plug and PCB are in good condition. If any of
these items are damaged, do NOT use the product.

● Do not pull, twist or bend the cord.

● NEVER leave the heater on unattended.

● ALWAYS unplug the heater before starting your

engine.

● NEVER refuel your car with the heater connected.

TKPC9000

Instruction Manual