TracRac IM TracRac - Manual (Page 11)

TracRac INSTRUCTION MANUAL 11 TracRac Inc. 994 Jefferson Street, Fall River, MA 02721-4893 • 508-677-4130
8. Repeat steps 1 through 7 for the rear corner units. Mount
the rear rack onto the inner tracks for maximum capacity
and strength.
CAUTION: All fasteners in overhead rack assembly must be
tightened to a torque specification of (20-25 ft-lbs).
9. Slide the crossbar tiedowns onto the overhead rack
crossbars. (Note: Loosen knob, then insert the T-bolt into
the groove first).
10. Mount all four cleats onto the uprights using the
1/4 x 1-3/4 socket screws; two screws for each cleat.
11. If no other accessories are to be installed, insert the
remaining four 1/4-20 x 3/8” safety locking bolts into the
threaded holes at the tailgate end of the base rails.
Congratulations – Racks are now installed and can slide to
any position along the bed of the truck.
CAUTION: All 1/4-20 x 3/8” safety locking bolts must be
installed, and all knobs tightened prior to operating the
vehicle on the road.
TracRac is capable of carrying a maximum of 1000 lbs.,
evenly distributed when configured with the rear rack
mounted on the inner track.
For good performance and safety, periodically check that
the base rails remain parallel and secure. Re-torque all fas-
teners to the proper specification after the first 500 miles,
and every 10,000 miles thereafter. Lubricate the threaded
portion of all knobs every 2000 miles.
Carrying high loads over rough roads with excess speed
may damage the system. Exercise good judgment at all
times.
Please review the enclosed CAUTION sheet for additional
guidelines.