SoundMax SM-CDM1052 - Manual (Page 13)

13
RADIO mode), DSP (FLAT/CLAS/ROCK/POP), LOUD OFF/LOUD ON, STEREO/MONO (in RADIO
mode), DX/LOCAL (in RADIO mode), VOL LAST/VOL ADJUST, ESP6/ESP25.
Rotate VOLUME knob to set the parameter. Press SEL button to confirm the setting.
-
TA SEEK/TA ALARM:
TA seek: when newly tuned station does not receive TP information for 60 seconds, the radio
retunes to next station which has not the same station (PI) as the last station, but has the TP
information.
When TP information gets lost at the current station for retune time selected (60 or 90
seconds), the radio start to retune to next same PI station. When same PI station does not
catch in 1 cyclic search, the radio retunes to next station with TP information.
TA alarm: when this mode is selected, any automatic retune mode is not activated. Only
double beep sound (ALARM) is output.
When newly tuned station does not have TP information for 5 seconds, a beep comes out. When
TP information is missing from the current station for retune time, beeps will be heard. When
newly tuned station does not have RDS signal, PI SEEK will pause.
-
PI SOUND/PI MUTE:
PI sound: If a car is cruising between buildings, an oscillation phenomenon may occur, due to
different PI codes being received from the same AF.
PI mute: In above situation, the sound will be muted for less than 1 second.
-
RETUNE L/RETUNE S:
The initial time of automatic TA search or PI SEARCH mode is selected. When PI information is
not received for retune time, the radio will search for the next, same PI station. When same PI
station is not received during 1 cyclic search, the radio will switch to the last station and wait
4-5 minutes for PI code.
Retune L: selected as 90 seconds.