Tiptop Z3000 Smzrt VCO MKII - Manual (Page 4)

Frequency Mode.
Frequency Mode is the Z3000mkII’s first mode and is
the mode that the module starts in when powered. It
works by counting the wave cycles generated by the
VCO for one second and then shows the results on
the display with a resolution of 1Hz. The display ranges
from 1Hzup to 9999Hz. When frequencies pass above
the maximum range of 9999Hz the display shuts off,
this is normal. Similarly, when frequencies pass below
the lower limit of 1Hz the display blinks the word LFO
(Low Frequency Oscillator).
The display of the Z3000mkII is fully synchronized with
the VCO frequency and blinks accordingly at low
frequencies. Each time the display comes on, it
indicates the start of a new wave. This is especially
useful at low frequencies when the VCO is used as a
clock generator or LFO.
LFO 1Hz 9999Hz Display Off
MIN MAX
MIN MAX
LOW HIGH
SYNC HSM
1V/Oct 1V/Oct
Linear FM
INPUT
PWM FM 1
LOW HIGH
Hz
Oct
FM 2
INPUT
CV IN INPUT
CV IN CV OUT
INPUT INPUT
+
+ +
+
EXT IN
FREQUENCY/NOTE/OCTAVE
Tipt p
A u d i o
Z 3 0 0 0
Smart VC-­Oscillator FREQUENCY
FINE TUNE
PULSE WIDTH
PWM
FM
MIN MAX
MIN MAX
LOW HIGH
SYNC HSM
1V/Oct 1V/Oct
Linear FM
INPUT
PWM FM 1
LOW HIGH
Hz
Oct
FM 2
INPUT
CV IN INPUT
CV IN CV OUT
INPUT INPUT
+
+ +
+
EXT IN
FREQUENCY/NOTE/OCTAVE
Tipt p
A u d i o
Z 3 0 0 0
Smart VC-­Oscillator FREQUENCY
FINE TUNE
PULSE WIDTH
PWM
FM
SYNC HSM
1V/Oct EXT-­IN
Linear FM
INPUT
PWM FM 1
FM 2
CV IN INPUT
CV IN INPUT
INPUT INPUT
+
+ +
+
Tipt p
A u d i o
Z 3 0 0 0
Hz
Oct
FREQUENCY/NOTE/OCTAVE
FM
PWM
PULSE WIDTH
FINE TUNE
MAX MIN
MIN MAX
LOW HIGH
LOW
SHAPER
WAVE
FREQUENCY Smart VC-­Oscillator
HIGH
SYNC HSM
1V/Oct EXT-­IN
Linear FM
INPUT
PWM FM 1
FM 2
CV IN INPUT
CV IN INPUT
INPUT INPUT
+
+ +
+
Tipt p
A u d i o
Z 3 0 0 0
Hz
Oct
FREQUENCY/NOTE/OCTAVE
FM
PWM
PULSE WIDTH
FINE TUNE
MAX MIN
MIN MAX
LOW HIGH
LOW
SHAPER
WAVE
FREQUENCY Smart VC-­Oscillator
HIGH