Tiptop Z3000 Smzrt VCO MKII - Manual (Page 11)

SYNC HSM
1V/Oct EXT-­IN
Linear FM
INPUT
PWM FM 1
FM 2
CV IN INPUT
CV IN INPUT
INPUT INPUT
+
+ +
+
Tipt p
A u d i o
Z 3 0 0 0
Hz
Oct
FREQUENCY/NOTE/OCTAVE
FM
PWM
PULSE WIDTH
FINE TUNE
MAX MIN
MIN MAX
LOW HIGH
LOW
SHAPER
WAVE
FREQUENCY Smart VC-­Oscillator
HIGH
SYNC HSM
1V/Oct EXT-­IN
Linear FM
INPUT
PWM FM 1
FM 2
CV IN INPUT
CV IN INPUT
INPUT INPUT
+
+ +
+
Tipt p
A u d i o
Z 3 0 0 0
Hz
Oct
FREQUENCY/NOTE/OCTAVE
FM
PWM
PULSE WIDTH
FINE TUNE
MAX MIN
MIN MAX
LOW HIGH
LOW
SHAPER
WAVE
FREQUENCY Smart VC-­Oscillator
HIGH
1V/Oct CV Input
1V/Oct
CV IN
1V/Oct
CV IN CV Stack
It should be known that the CV bus can be enabled
using the HD2 jumper on the main PCB. Further, this
will not override the 1V/Oct CV input on the front
panel.
The Z3000mkII’s 1V/Oct CV Input has a very high
resistance-input designed to allow you to stack CV
signals from a CV source before entering the unit
without encountering tuning error, or “CV Drop.”
With the the release of our Stackcables there was no
longer a need for a built in CV mult. The available
space made it possible to bring out the waveshaping
ability. The Waveshaper Input is described further in
this manual on page 14-2.
TM