Delphi SA10034-11B1 - Manual (Page 6)

Basic Operations
CD/MP3, AM/FM, CLOCK MODULE
Playing Audio CD or MP3 Files
The Delphi CD Audio System can play CDs, CD-Rs,
and CD-RWs recorded in Compact Disc Digital Audio
(CD-DA) format, as well as MP3 files recorded in CD-
ROM format**. Playback may vary depending on
the quality of the compact disc and the condition of
the recording device.
To play compact discs:
1. Rotate the central unit so that the CD panel faces
forward. Be sure to follow the arrows when
rotating the unit. Complete the rotation until the
unit locks in position. CAUTION: Do not use
excessive force, which could damage the unit.
2. Press “Power” on the CD panel or remote control.
3. Holding the central unit steady, open the
compartment lid and insert a compact disc in
the CD player.
4. Close the CD compartment lid.
Before playing a compact disc, your Delphi CD
Audio System reads all file and directory informa-
tion on the CD. Depending on file structure, this may
take more than one minute. “READING” is displayed
during this time. The first track on the CD will begin
to play automatically. At the same time, information
about the disc will display.
Figure 6: Initial CD Display
Figure 7: Initial MP3 Display
Proper Care and Storage of Compact
Discs
Scratches, dirt, and fingerprints on the surface of
compact discs may cause tracking errors. For opti-
mum sound quality:
• Compact discs should be cleaned before playing;
using a dry, soft cloth, wipe from the center out,
never in a circular motion
• Do not clean compact discs with benzene or
other solvents, commercially available cleaners,
or antistatic spray intended for vinyl LPs
• Store CDs in their cases when not playing
• Do not allow CDs to be exposed to direct sun-
light or heat sources
• Do not tape paper or apply stickers to CDs
CD/MP3 Programming Options
Your Delphi CD Audio System lets you program the
playing order of up to 30 CD/MP3 tracks or MP3
directories.
CD Program Play
To program the playing order of tracks on a CD:
1. In CD/MP3 mode, stop playback.
2. Press “Memory” on the CD panel or “mem/prog”
on the remote. “P01_ _” will flash on the LCD.
3. Press “Next” or “Prev” on the CD panel or the
category keys or numeric keys on the remote to
select a track number.
4. Press “Memory” or “mem/prog” to confirm.
5. “P02_ _” will flash. Continue Steps 3 and 4 until
all tracks have been selected (up to a maximum
of 30).
6. Press “Play” on the CD panel or the enter key on
the remote to play.
Figure 8: Display During CD Programming
MP3 Program Play
To program the playing order of tracks or directories
on an MP3:
1. In CD/MP3 mode, stop playback.
2. Press “Memory” on the CD panel or “mem/prog”
on the remote. “P01_ _ _-_ _ _” will display and
the first three _ _ _ (dashes in the register) will
flash on the LCD.
3. Press “Next” or “Prev” on the CD panel or the
category keys or numeric keys on the remote to
select a directory.
4
SECT
ION 3
**Recording MP3 files for the Delphi CD Audio System may require the
use of “Full Version” CD-burning software packages (e.g., EasyCD
Creator ™ or Nero ™ ).
CD
15 TRK
72:46
CD
P01-XX
MP3
22 DIR
185 TRK
Total track numbers
Total playback time
Total directory numbers
Total track numbers
Track number
Program number