Delphi SA10034-11B1 - Manual (Page 10)

Figure 15
3. Holding the central unit steady, press the back of
the inset cradle, then allow it to tilt forward.
Carefully slide the SKYFi Receiver down into the
cradle (Figure 16). The alignment slots on the
receiver should line up with the tabs inside the
cradle. At the same time, the receiver should be
securely seated with the connector. Press the top
center of the SKYFi Receiver display, tilting it
back into the Delphi CD Audio System with a
firm but gentle click. Remove the SKYFi Receiver
by reversing this process (Figure 17).
Figure 16: Insertion of SKYFi
Receiver Into Cradle
Figure 17: SKYFi Receiver
Removal From Cradle
4. Press “Power” on the SKYFi Receiver or Delphi
CD Audio System remote to power up SKYFi.
5. If the display reads “ANTENNA” after powering
up, check that the antenna connection is secure
and completely engaged. Next, change channels
(from 0 to 1 or from 1 to 0 if the receiver is not
yet activated). If the “ANTENNA” message
remains, power down the radio, unplug the
antenna, and look for any obvious damage to
the connector, jack, or antenna cable. If no
damage is detected, reconnect the antenna, turn
the unit back on, and change channels again.
Contact your retailer if the message still appears.
6. If the display reads “NO SIGNAL” after powering
up, follow the instructions below and on page 9
for positioning the XM antenna and optimizing its
signal.
Once the Delphi CD Audio System is set up and the
SKYFi Receiver is inserted in its cradle, refer to the
SKYFi Operating Guide for complete system opera-
tion and control information.
Positioning the XM Antenna
The XM antenna that comes with your Delphi CD
Audio System is a high-gain antenna that can
receive XM’s signal from XM’s satellites and/or,
depending on where you live, XM’s land-based
repeaters. It is recommended that the antenna be
positioned near a south-facing window or outdoors
with a clear view of the southern sky in order to
receive the satellite signal. In some cases, it will be
possible to receive XM’s signal through standard
home walls or a roof.
To position your antenna, first set up the Delphi CD
Audio System as described earlier in this guide.
Next, position the antenna until you receive the
strongest possible satellite signal (refer to Optimizing
XM Antenna Signal, page 9). If a satellite signal is
not available, you can optimize your antenna for a
terrestrial signal (signal from land repeater, where
available).
Figure 18
8
PRESS MENU TO EXIT
SATELLITE
Terrestrial
SECT
ION 3