StorCase Technology 12-Bay 4U Fibre/SATA JBOD - Manual (Page 20)

InfoStation 12-Bay JBOD User's Guide - Rev. A00 StorCase Technology, Inc.
FC Configurations 11
TYPICAL FIBRE CHANNEL CONFIGURATION
CAUTION: DO NOT bend the LC (optical) cable beyond the cable's minimum bend radius,
data transmission degradation may occur. Follow cable manufacturer's
guidelines for bend radius limitation.
WARNING: DO NOT look directly into the open end of an active LC (optical) cable or optical
SFP module (with plugs removed)! Serious eye damage can occur from direct
exposure to the infrared light!
NOTES: The configuration and use of the InfoStation JBOD Controller requires a certain
level of expertise and experience on the part of the user/integrator. Since there
are many configuration options and variables (ie. host platforms, applications,
etc.), only general guidelines will be discussed in this User's Guide.
LC (optical) SFP Modules support both 2Gbps and 1Gbps operation.
Figure 6: FC Ports and LEDs
Loop B Loop A
ST
ACT ST
ACT
Status LED
Activity LED
FC Ports
LEDs
Status - ON = Steady glow during power up indicates JBOD controller initialization
(will turn OFF once initialization is complete and if SFP is not connec-
ted to Host). LED will remain ON if SFP is connected to Host.
Activity - ON = Steady glow indicates activity
(Blue)