StorCase Technology DS60 - Manual (Page 4)

DS60 Installation Instructions - Rev. C02 StorCase Technology, Inc.
Installation 1
Figure 1: Removing the Cover
(1-Bay Shown)
DATA STACKER INSTALLATION
Installing the Drive(s) into the Data Stacker
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive(s) being installed. Also refer to the manufacturer's documentation provided with
the drive(s).
Phillips #1 and #2 screwdrivers will be required during this procedure.
NOTE: For the DS60 2-bay model, always install bottom drive first!
Removing the DS60 Cover
WARNING: Remove ALL power from the Data Stacker before removing the cover. The Data
Stacker contains NO USER SERVICEABLE PARTS inside the unit.
1. Unplug the Data Stacker and verify that ALL cables have been disconnected.
2. Remove the two (2) screws located on the back of the unit as shown (Figure 1).
3. Carefully slide the cover forward, then lift upward and off the chassis.