StorCase Technology DS60 - Manual (Page 11)

8 Installation
StorCase Technology, Inc. DS60 Installation Instructions - Rev. C02
8. Locate the device activity connector on the drive and connect the black/green wires
to these pins. Black is connected to the cathode output and green is connected to the
anode output.
9. Locate the device fault connector on the drive and connect the black/yellow wires to
these pins. Black is connected to the cathode output and yellow is connected to the
anode output.
Refer to the device manufacturer's documentation for the location of these pins.
10. Carefully reinstall the sliding drive bracket/drive into the Data Stacker chassis and
fasten it into place with the retaining screw.
IMPORTANT NOTE: Be careful not to damage the connector pins on the backside of the
interchangeable drive bezel (behind the LEDs) when installing the
sliding drive bezel into the chassis! If you encounter resistance,
do not force the bracket into place!
11. Attach the 4-pin DC power cable to the drive.
12. Attach the I/O cable to the drive.
13. Reinstall the chassis side panel.
14. Reinstall the Data Stacker top cover in the reverse manner in which it was removed.
Make certain that the tongue on the underside of the cover mates with the groove in
the front bezel (Figure 1).
15. Connect the power cable to the Data Stacker and turn on the power switch. Should
there be any unusual sound, turn the Data Stacker off immediately, disconnect the
power cable, and remove the cover to locate the source of the problem. Verify that
the power, SCSI ID select cables and LED cables are securely fastened with the
provided tie wraps and are not contacting the fan. Replace the cover.