StorCase Technology S20A124 - Manual (Page 14)

S20A124 User's Guide - Rev. B01 StorCase Technology, Inc.
Installation 7
INSTALLATION
Installing the Drive in the Carrier
Preparation
While performing the steps in this section, work on a soft surface to prevent excessive shock
to the drive being installed. Also refer to the manufacturer's documentation provided with the
drive.
NOTE: A #2 Phillips screwdriver will be required during this procedure.
1. Remove the drive from its protective packaging.
2. Plastic Drive Bezel: If the drive came equipped with a plastic front bezel, it
must be removed.
3. SCSI Drive Termination: The DE300 does not provide onboard termination.
External termination must be provided. Refer to the documentation provided
by the drive manufacturer for termination information.
Installation
1. Carefully insert the drive into the carrier and bottom-mount the drive using four
(4) #6-32 Phillips Flat Hd. screws (Figure 6).
2. Install the drive cover by inserting the front lip of the cover under the front inside
face of the carrier. Carefully push down on the rear of the cover so that the
side flanges align with the rear side-mounting holes on the drive (Figure 6). The
drive cover should sit flush with the top and rear of the carrier. Fasten the cover
into place with two (2) #6-32 Phillips Pan Hd. screws.