StorCase Technology DE300i-SWC - Manual (Page 18)

DE300i-SWC User's Guide - Rev. A00 StorCase Technology Inc.
Installation 11
4. With the drive carriers locked into place inside the receiving frame, install the
DE300i-SWC receiving frame into the drive opening in the computer or
expansion chassis. Use the appropriate guides to position the DE300i-SWC,
and fasten it into place with the four (4) #6-32 x 1/4” screws provided.
Figure 8 illustrates the location of the mounting holes. Mounting holes are
provided on each side and the bottom of the receiving frame to
accommodate a variety of mounting configurations. Use the mounting holes
which best suit the computer or expansion chassis configuration.
Figure 8: Receiving Frame Mounting Holes
Mounting
Holes
(Right)
0520
Mounting
Holes
(Bottom)
Front of Unit
5. Adjust the front of the receiving frame so the carrier slides freely in and out
on the receiving frame guides. The position of adjoining peripheral units may
require adjustment.
6. To connect a drive to a Remote Activity LED in the computer system or
expansion chassis, connect the appropriate cable(s) to the receiving frame
motherboard as shown in Figure 5. Connect J3A, J3B, and J3C Pins 11 and
12 to a remote activity LED.
7. Connect the I/O cables from the host adapter to the receiving frame. The Pin
1 indicator on the cable must be properly aligned. Refer to Figure 5 for the
correct Pin 1 location.
8. Make sure that only the last SCSI device is terminated. If the DE300i-SWC is
at the end of a daisy chain, the receiving frame termination for the last
device must be enabled by removing the appropriate jumper. If the
DE300i-SWC is in the middle of a daisy chain, termination should be disabled
(jumper installed, factory setting) at J3A, J3B, and J3C, Pins 9 and 10
(Figure 7).