StorCase Technology DE100i-SWU2X - Manual (Page 33)

StorCase Technology, Inc. DE100i-SWU2X User's Guide - Rev. B01
26 Appendix D - Optional Accessories
Drive Plug
0429
Slip Drive Cover
Lip into Top Rear
of Carrier. The
Sides of the Cover
Will Fit Between
the Drive and the
Carrier. Mounting
Holes Must be
Towards Rear of
Carrier. 1
Swing Drive Cover
Down, Covering
the Drive. Make
Certain You Do
Not Damage
Connector Pins or
Cables. 2
Slide Drive Cover
Forward Making Certain
Front Cover Lip is Inside
Carrier. Fasten Screws. 3
Full Drive Cover (optional)
Disk
Carrier
Drive
Cover
Mounting
Holes
1
2
3
0067
Drive Cover
Figure D-2: Full Drive Cover
The full drive cover (P/N DX100-COV) is an attractive metal cover which can provide additional
protection for 3.5" half-height drives, preventing foreign material from coming in contact with
the drive and cables. The full drive cover is similar to the cable cover provided with the
DE100i-SWU2X, except the full drive cover protects the drive as well as the cables. It is easily
installed with two (2) #6-32 Phillips Flat Hd. screws as shown in the illustration above.
NOTE: The full drive cover may not be compatible with all 3.5" half-height drives. Exact drive
height and fit within the Data Express frame can vary between drive manufacturers.
Please contact StorCase for technical assistance before ordering the full drive cover.
Figure D-3: Drive Plug
The drive plug (P/N DX100-PLUG), is designed to fill system or external enclosure bays that
are occupied by receiving frames that have no carrier units installed. The purpose of the plug
is to provide an attractive and functional method of directing proper air flow to the other installed
devices in the system or external enclosure.