Receiving frame rear panel – StorCase Technology DE90i-A100 User Manual

Page 12

DE90i-A100 User's Guide - Rev. B02

StorCase Technology, Inc.

Introduction

Receiving Frame Rear Panel

(Figure 4)

DC Power Connector (J3): The DE90i-A100 uses a standard 4-pin DC Power

Connector to accept DC power.

I/O Connector (J2): The input/output connector provides a standard interface for

all IDE signals. See Table 2 for J2 pin assignments.

Master/Slave Selection Jumper (J5): Master Drive configuration (default).

Forces Master Drive configuration on receiving frame. Change jumper to set Slave

Drive configuration. Refer to Figure 7 for further information.

NOTE:

If both jumpers are installed or if both jumpers are removed, all front panel

indicator LEDs will flash indicating an error (refer to Table 1).

Device Spin Down/Up Timer Jumper (J6): Jumper installed (factory default)

enables device spin down/up visual indicator. Receiving frame front panel indicator

LED (Figure 3) will flash to indicate device spin down/up.

Figure 4: Receiving Frame (Rear View)