StorCase Technology DE75i-S - Manual (Page 15)

StorCase Technology, Inc. DE75i-S User's Guide - Rev. A01
8 Installation
Figure 6: Drive Installation Assembly
Installation
1. Attach the I/O cable from the carrier board to the drive (Figure 6).
2. Attach the 4-pin power cable from the carrier board to the drive (Figure 6).
3. Attach the appropriate ID select cable to the carrier board connector (Figure
7).
4. Carefully insert the drive into the carrier at an angle, cable-end first. Make sure
that none of the cables are pinched. Lower the front of the drive carefully
into place. Fasten the drive into the carrier with four (4) # 6-32 Phillips Flat Hd.
screws provided.
5. Attach the provided drive cover with two (2) #6-32 Phillips Flat Hd. screws.