Dixon 966 004201 - Manual (Page 8)

9
ASSEMBLY
5
CONTAINER MOUNTING
Install containers on supports, overlapping at 1.
center supports.
Close cover and lock latch handles over center
2.
support tubes.
Center
Support
Tubes
WARNING!
DO NOT operate mower unless container is
properly installed. Container is subject to
wear and deterioration, check containers
frequently, replace when cracked or
damaged. Use only a recommended
replacement container.
4
MOUNTING COVER ASSEMBLY
NOTE: Assistance from another person may ease
mounting the cover assembly to mower.
1. Lift and rotate cover to align the cover brackets
with support assembly tubes.
2. Slide the cover down over the support tubes until
secure.
Remove plastic end caps from the center two bag 1.
support arms. Fully insert spacer plugs into the
ends of the support tubes. It may be necessary
to tap the spacers into place with a hammer or
mallet. Replace the plastic end cap back over the
spacer. The additional extension will hold the hood
more securely when latched.
Remove center
end caps
Insert spacers
and replace caps
3
CONTAINER MOUNTING