Dixon 966 004201 - Manual (Page 7)

8
ASSEMBLY
1
INSTALLING BAGGER MOUNT
Install the bagger mount tube to the rear guard 1.
with 5 /
16
-18 x 3¼ bolts and flange nuts from kit.
NOTE: Depending on model, rear guard hole may
need to be drilled out to 5 /
16
" if kit hardware is too
large.
Install kit support straps on the outside of the
2.
mount tube as shown in the illustration. Using a
5 /
16
-18 x 1¼ bolt, attach the front side of the strap
to the fender support. Do not add flange nut at this
time. Place the reinforcement plate to the outside
of the fender support. Secure with additional 1¼
bolt and fasten both bolts with flange nuts. Repeat
steps on opposite side.
NOTE: The front side of the kit support straps
should be on the inside of the mower frame.
Tighten all hardware.
3.
Reinforcement Plate
Mount Tube
Support Strap
Drill rear
guard hole to
5 /
16
" if needed
1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two 3 /
8
holes into
bagger hood.
Upper Chute Support
Bagger Inlet
Nut
Bagger Hood
Flat Washers
Hex Bolt
Flex Trim
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
2
INSTALLING CHUTE SUPPORT