Star Headlight & Lantern Optimax-DH RP242 - Manual (Page 3)

2
Mounting the pak
Mount the pak on a smooth metal surface to allow for adequate heat dissipation. Do not mount
the pak near any external heat source as this will retard its ability to dissipate heat sufficiently.
Mount the Pak using four bolts (not included). When mounting, make sure a good electrical
connection exists between the mounting plate and the vehicle chassis. This will help to
eliminate any RF interference.
T1
OPTIMAX-RP242
L1 L2
PWR CTRL 15AMP
15AMP
CTRL PWR
OPTIMAX-RP244
T4
L2 L1
T2
HV
T3
L3 L4
L3
OPTIMAX-RP906
PWR CTRL
L1 L2 L4 L6 L5
RP310 SERIES
RP320/330
SERIES
6"
5 1
2
"
2 1
2
"
3
15
16
"
5 5
8
"
2 1
2
" 2 1
2
"
5 1
2
" 5 1
4
"
4 3
4
" 4 1
4
"
2 1
2
"
3 7
8
"
9"
9 1
2
"
1 1
4
"
1 1
4
"
6 3
4
"
6"
5"
4 1
2
"
When mounting the power pak and accessories, please be sure to
keep any radio frequency sensitive equipment at least 20” from the
power pak, cables, and/or wires which make up your strobe system.
The pak has been designed to limit RFI emissions , but certain very
sensitive equipment may still be affected. Symptoms may include,
but are not limited to, sporadic operation and degraded performance.
Star Headlight & Lantern Co., Inc. cannot assume any responsibility
for any radio frequency induced malfunction or damage to any
radios, sirens, lightbars, or any other equipment mounted within 20”
of this strobe system. Any antennae mounted in the proximity of the
system may cause your radio to suffer the aforementioned results.