Star Headlight & Lantern 8600 Series Intercepto - 66" Tow Packages - Manual (Page 4)

-1-
Minimum
LIGHT(S) WIRE COLOR AWG
Connect to Negative Side of Battery
-12 VDC /Ground/Neutral
Black 10
Connect to +12VDC
Rotating Halogen Lights
Orange 14
Secondary Rotator Orange w/Black Stripe 14
360° Strobe, 360° Halo, or Strobe Power Pack* Red 14
Front Strobe Heads On/Off (4-Head Packs Only) * White w/Green Stripe 22
Rear Strobe Heads On/Off (4-Head Packs Only) * Black w/Green Stripe 22
Pattern Select (Strobe and/or LED)‡ Red w/Green Stripe 22
Alternate Strobe Pack PWR Red w/Black Stripe 14
LED Flasher Power (LDF369 or LDF398) Orange w/Red Stripe 16
LED High/Low Control Purple 18
Front Take-Down/Work Lights Green w/Yellow Stripe 14
Rear Floods/Work Lights White w/Orange Stripe 14
Front Alternating Flashers White w/Brown Stripe 16
Rear Alternating Flashers White 16
Driver’s Side Alley Light Blue 16
Passenger Side Alley Light Gray 16
Left Turn Signal Yellow 16
Right Turn Signal Green 16
Tail Lights & ID Marker Lights Brown 18
Intersection Clearing Lights White w/Blue Stripe 18
Alternate Power Red w/White Stripe 14
Traffic Director † †
* See Remote Strobe Power Supply Connection section on pages 7-10
‡ See Pattern Programming section on page 11-13
† Separate Bundled 9-Conductor Cable
QUICK-INSTALL WIRING GUIDE
All lightbars are shipped with a Wire Harness Assembly Checklist that is unique to your bar and will
define what each wire controls. You can also use the chart below for general reference.
Please note: Depending upon the components in your lightbar, the wire colors used in your
harness may differ slightly from the chart below.
Wire Harness Usage Chart
‡ Please note: If you have a lightbar with a strobe pack or LED flasher, the
Red w/Green Stripe wire is only used when programming the flash pattern.
This wire MUST NOT be connected to continuous +12VDC!!! Once the
pattern has been selected, tape the end of this wire off. (See page 11)