Star Headlight & Lantern BKDLXT - Manual (Page 4)

-4-
If you have any questions concerning this or any other product,
please contact our Customer Service Department at (585) 226-9787.
If a product must be returned for any reason, please contact our Customer Service Department to
obtain a Returned Material Authorization number (RMA #) before you ship the product back.
Please write the RMA # clearly on the package near the mailing label.
LED FIVE YEAR LIMITED WARRANTY
The manufacturer warrants this LED light against factory defects in material and workmanship for five years
after the date of purchase. The owner will be responsible for returning to the Service Center any defective
item(s) with the transportation costs prepaid. The manufacturer will, without charge, repair or replace at its
option, products, or part(s), which its inspection determines to be defective. Repaired or replacement
item(s) will be returned to the purchaser with transportation costs prepaid from the service point. A copy of
the purchaser's receipt must be returned with the defective item(s) in order to qualify for the warranty
coverage. Exclusions from this warranty include, but are not limited to, domes, and/or the finish. This
warranty shall not apply to any light, which has been altered, such that in the manufacturer's judgment, the
performance or reliability has been affected, or if any damage has resulted from abnormal use or service.
There are no warranties expressed or implied (including any warranty of merchantability or fitness), which
extend this warranty period. The loss of use of the product, loss of time, inconvenience, commercial loss or
consequential damages, including costs of any labor, are not covered. The manufacturer reserves the right
to change the design of the product without assuming any obligation to modify any product previously
manufactured.
This warranty gives you specific legal rights. You might also have additional rights that may vary from state to
state. Some states do not allow limitations on how long an implied warranty lasts. Some states do not allow
the exclusion or limitation of incidental or consequential damages. Therefore, the above limitation(s) or
exclusion(s) may not apply to you.
NOTICE
Due to continuous product improvements, we must reserve the right to change any specifications and information, contained in this
manual at any time without notice. Star Headlight & Lantern Co., Inc. makes no warranty of any kind with regard to this manual,
including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Star Headlight &
Lantern Co., Inc. shall not be liable for errors contained herein or for incidental or consequential damages in connection with the
furnishing, performance, or use of this manual.
Steady Burn Programming
Programming Steady Burn Pattern in Single Mode:
1. Connect the heads you wish to be steady burn to the BKLD418-2 and power it up.
2. Hold a screwdriver across both Pattern Programming Pins until the light(s) blink(s)s six
times (approximately 18 seconds), then release it. The light(s) should change to the
Steady Burn pattern.
3. To exit Steady Burn pattern touch and release a screwdriver to both Pattern
Programming Pins.
Programming Steady Burn Pattern in Split Mode:
1. Connect heads, apply power, and program for Steady Burn as described above for
Single Mode. One of the two halves will become steady, while the other flashes.
2. To change the pattern on the flashing side, touch and release a screwdriver to both
Pattern Programming Pins.
3. To flip-flop the steady side and the flashing sides, hold a screwdriver across both
Pattern Programming Pins until the light flashes 5 times (approximately 15 seconds) and
then release it.
4. To exit Steady Burn pattern hold a screwdriver across both Pattern Programming Pins
until the light(s) blink(s) six times (approximately 18 seconds), then release it.