Spectrum Controls 1746sc-OAP8I - Manual (Page 13)

Installation Instructions
Isolated-Circuit
Discrete Input and Output Modules
11
!
Important Pre-Installation Considerations
This module is shipped in a static-shielded container to guard against electro-
static discharge damage. Observe the following precautions when handling
the module:
CAUTION
ELECTROSTATICALLY SENSITIVE COMPONENTS
Observe the following precautions to guard against electrostatic damage:
• Wear an approved wrist strap grounding device, or touch a grounded
object to discharge yourself before handling the module.
• Do not touch the gold backplane connector or connector pins.
• If available, use a static-free work station.
• When not in use, keep the module in a static-shielded bag.
Failure to observe these precautions can damage your module.
When using Allen-Bradley Programming Software (APS) to configure a
chassis slot for your module, simply select your module from the list of
modules on the system I/O configuration display. (Note: Some versions of
APS list the modules without the “sc” designation, as in 1746-IA8I.) If your
module is not listed, select OTHER at the bottom of the list and enter your
module’s ID code at the prompt:
Module ID Code
1746sc-IA8I 303 1746sc-IM8I 304
1746sc-IB8I/-IC8I 324 1746sc-OAP8I 1905