Spectrum Controls 1794sc-IF8IU - Manual (Page 21)

Chapter 2: Installation and Wiring 2-11
User's Manual Pub. 0300231‐01 Rev. A
!
Attention
The IF8IU module does not receive power from the backplane. +24V
dc power must be applied to your module before operation. If power
is not applied, the module position will appear to the adapter as an
empty slot in your chassis. If the adapter does not recognize your
module after installation is completed, cycle power to the adapter.
!
Attention
Use supply wire for 10˚C above surrounding ambient.
Figure 2-1
Table 2-1
Type of Input
Connect The Following
R IN+ IN- I Shield 1
RTD/Res 2-wire 1 2
RTD/Res 3-wire 0 1 2
Thermocouple 1 2
V/mV Source 1 2
mA Source 1 2 3
1 Shield can be connected to chassis ground terminals 16, 33,
and 40…45.