beautypg.com

Ttach, Estraint, Installation of casters – Southbend 4601DD-2RR User Manual

Page 8

background image

U

LTIMATE

R

ESTAURANT

R

ANGES

OWNER’S MANUAL 1190820 REV 4 (10/14)

PAGE 8

OF 34

A set of four casters is packed with ranges ordered with casters (instead of legs).
A threaded leg pad is fastened to the base frame at each corner. Each caster has a corresponding mating thread. The

casters can be adjusted to overcome a slightly uneven floor. Casters are provided with a fitting for proper lubrication

when required.
1. Raise range sufficiently to allow the casters to be attached. For safety, “shore up” and support the range with an

adequate blocking arrangement strong enough to support the load.
2. Screw the casters into the holes in the centers of the leg pads. Install the casters that have a locking brake under the

front of the range.
3. Lower range gently onto a level surface. Never drop or allow the range to fall.
4. Use a level to make sure that the range surface is level. The casters can be screwed in or out slightly to lower or

raise each corner of the range.
5. Go to Installation Step 3

I

NSTALLATION

S

TEP

2

C:

A

TTACH

R

ESTRAINT

NOTICE

For an appliance equipped with casters, (1) the installation shall be made with a connector that complies with the

Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Movable Gas Appliances, CAN/

CGA-6.16, and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for Use With

Gas Fuel, ANSI Z21.41, or Quick Disconnect Devices for Use with Gas Fuel, CAN1-6.9, (2) adequate means must be

provided to limit the movement of the appliance without depending on the connector and the quick-disconnect device

or its associated piping to limit the appliance movement, and (3) the restraining means should be attached to a frame

member on the back of the unit.

Installation of Casters

Figure 3

1. Secure the restraining-device bracket (item “B” in the following illustration) to a wall stud located as close as possible

to the appliance connector inlet and outlet connections. Use four #12 screws (items “C”) and plastic anchors (items

“A”) if necessary.

This manual is related to the following products: