SkyRC Quattro Micro Battery Charger - Manual (Page 3)

When the charging process is finished, the status LED turn green and blinks 5 times with audible
sound. And the status LED stays green and the 4-digital LED will display “FULL”.
Insert the battery lead to the right battery connector.
Note: Please make sure insert the battery polarities correctly.
Select the charging current (0.1-1A) by rotating the dial.
Press and hold START/STOP button for 3 seconds to start charging process. The related status
LED will turn red with long beep.
During the charging process, the 4 digital LED will display charging capacity, battery voltage and
charging current circularly.
The LED will stay red during the whole charging process.
Press and hold START/STOP button for 3 seconds during charging process to stop charging.
OPERATING
4 DIGITAL LED MESSAGE DISPLAY
Status: Charging process finish.
Charging Current(A)
(0.10-1.00A)
Charging Capacity(mAh)
3
1.
2.
3.
4.
5.
6.
Note: You are not able to adjust the charging current during charging process.
Charging Capacity(mAh) Battery Voltage(V) Charging Current(A)
At this time, if you press the “START/STOP” button once, the 4-digital LED will display “FULL”, battery voltage
and battery capacity circularly. Note:
Battery Voltage(V)
7.
Battery Voltage(V) Charging Capacity(mAh)