Record – Rocktron MultiValve User Manual

Page 59

To dump a single MultiValve preset into a sequencer

Operating the MultiValve

Note: When performing data dumps to and from the MultiValve, always perform the dump in real time

sequence mode. This will ensure that data loaded back into the MultiValve

is not sent faster than

the MultiValve can receive it.

Also, make sure that the sequencer's MIDI filter is set to accept SYSX information.

Connect a standard MIDI cable from the MIDI OUT of the transmitting MultiValve to the
MIDI IN on the receiving sequencer.

Step 1

Step 2

Turn the FUNCTION SELECT controls on the transmitting MultiValve until "MIDI DUMP/
LOAD" is displayed.

Step 3

Turn the PARAMETER SELECT control on the transmitting MultiValve until "BULK
DUMP/LOAD" is displayed.

MIDI DUMP/LOAD

BULK DUMP/LOAD

TRANSMITTING MULTIVALVE

Step 4

Start the sequencer recording.

RECORD