REFCO DIGIMON4 - Manual (Page 18)

English Instruction Manual DIGIMON-SE / DIGIMON4
16
Resetting pressure sensors
By pressing the and buttons the DIGIMON pressure displays are
reset to zero, in order to avoid incorrect measurement values.
To obtain a correct measurement value on the display, the DIGIMON
should not be reset when pressurised or under a vacuum.
Factory settings
 Set the DIGIMON to the "Digital display" screen.
 Press the and buttons at the same time for 5 seconds.
 Display shows - - - - - - - -
 Press the button to exit.
Resetting the external vacuum sensor
 Switch off the DIGIMON
 Connect vacuum sensor
 Hold down the button and switch on the device using the
button.

Display shows VAC-ZERO
 Press the button to exit  display shows End.
 The device can be switched on using the button and is ready for
operation once again.
ON/OFF
SET
ON/OFF VAC
SET
VAC LIGHT
LIGHT SET