RAVE Sports Classic Aqua Jump 25' Water Park - Manual (Page 11)

10
At each of the frame holders on the tube, pull the strap over
the frame, through both stainless steel rings, and then back
under the front ring. Do not fully
tighten until all straps are loosely in
place around the frame. When all the
straps are in place, and the frame is
evenly centered on the tube, tighten
each securely, ensuring that the frame
lies flat against the tube in all
directions.
Attach the jumping mat
Lay the jumping mat inside the assembled frame with the
warning labels of the mat facing up. Attach the mat to the
frame by hooking one end of the spring to the V-ring on the
mat and the other end to the hole in the frame. Make sure that
the hooks on each end of the spring point down toward the
ground and are fully inserted into the frame.
Note: To ease the process, start by attaching a spring at one
point on the frame. Working in a clockwise direction, count the
appropriate number of holes and V rings until you are one
quarter around the frame. Attach a spring. Repeat until you
reach your starting point. Place one spring midway between
each existing spring around the entire jump. Repeat the
process until all springs are on the jump.