RAVE Sports Aqua Jump Eclipse 200 Water Park - Manual (Page 18)

:::::::::::::::::::::::: Important Information ::::::::::::::::::::::::::::
Rodents, like muskrats, may be attracted to the PVC vinyl of your product. When your
product is on the water, maintaining full air pressure during periods of non-use will
discourage them from chewing the vinyl.
Another way to ease the problem of nuisance rodents is to remove the temptation by
taking the product out of the water at night. You can also make the whole area
unattractive to rodents by changing the environment, making the area less hospitable for
rodents. Removing any food source from the shoreline can also be a good deterrent.
Check with your local DNR for additional guidance or possible restrictions.
Repairs
For large holes, tears or seam failures, contact RAVE Sports at 1-800-
659-0790. Extra repair patches can be purchased online at
www.ravesports.com. For minor holes or tears:
 Inflate the product and locate the leak by spraying the tube with
mild soapy water.
 Determine the hole size and cut a patch 1-2 inches wider than the
diameter of the hole. Make sure all corners of the patch are
rounded.
 Deflate the product and clean the patch and area around the hole
with rubbing alcohol. Let dry completely.
 READ AND UNDERSTAND THE WARNINGS ON THE GLUE
CONTAINER.
 Apply glue to the patch and the area around the hole. Let the glue
dry until it is tacky to the touch. (Approximately 1-2 minutes.)
 Lay the product on a flat, hard surface and apply the patch.
Working from the center to the outer edge, rub out any air
bubbles between the patch and the product.
 Let the patch dry for at least 24 hours before attempting to inflate
the product.
17