RAVE Sports Aqua Jump Eclipse 200 Water Park - Manual (Page 13)

Ensure webbing loop is lying
flat across the entire width
of the quick link as shown.
Repeat for other strap.
IMPORTANT: Properly
mounted, the ladder straps should run parallel to each other around
the tube with three springs and Δ-rings between the ladder straps as
shown.
NOTE: The AJ120 has a unique ladder. Please refer to the special
instruction sheet included with that product for assembly
instructions. The method to attach the ladder to the tube is the
same as described above.
Attach the Spring Pad Cover
Lay the spring pad cover on the trampoline so it covers the springs.
Note that the pad is blue on one side and green on the other. Orient
the pad so the blue or green side faces up to match the color of your
Aqua Jump Eclipse tube and the straight sides of the pad align with
the straight sides of the tube.
Note: If you have an Aqua Slide, determine the
panel section where you will want to attach the Slide.
One of the sections of the pad has two slots in it for
attaching the Slide. Position the pad so the slotted
section is on the section of the tube where you want
to attach the Slide.
Note: if you are using the green side up, you will need to reverse the
Velcro® attachment straps so they are pointing down. Push one end
through the slit in the pad then feed the other end down through
that same slit so both ends of the strap are sticking out of the
underside (blue side) of the pad. Center the strap so the legs are
equal length.
12