RAVE Sports Aqua Jump Eclipse 200 Water Park - Manual (Page 16)

Anchoring the Product (cont’d)
• On the AJ120, connect the anchor line directly to
the ring located opposite the ladder on the inside
of the tube.
• All Units: Adjust length of anchor line so that it is
approximately 1-2 ft. longer than the depth of the water. The
RAVE Sports anchor connector shock cord will provide 2 ft. of
stretch to absorb waves and any vertical bouncing motion. To
help prevent flipping of your Eclipse in high wind conditions, do
not exceed 3 ft. of total slack in the anchor line.
NOTE: More slack will improve anchor holding performance, but
too much slack may allow the Aqua Jump Eclipse to stand on edge
and flip over in strong winds. For best results, maximize your
anchor holding power via more weight or a different type of
anchor and minimize your anchor line length.
Operations
Inspect the trampoline before each use and replace any worn,
defective or missing parts.
The following conditions could represent potential hazards:
• Punctures or holes worn in the jump surface
• Deterioration in the stitching of the jump surface
• Stretched springs
• Missing or insecurely attached safety pads
• Sagging jump surface
• Unsecured against unauthorized use
• Regularly inspect the condition of the inflatable tube. Any
repairs should be done immediately
15