beautypg.com

After starting playback, English – Denon 685 User Manual

Page 36

background image

36

• To increase the bass or treble: Turn the control clockwise.

(The bass or treble sound can be increased to up to +12 dB
in steps of 2 dB.)

• To decrease the bass or treble: Turn the control

counterclockwise. (The bass or treble sound can be
decreased to up to –12 dB in steps of 2 dB.)

To select the surround mode while adjusting
the surround parameters, tone defeat or
tone control, press the surround mode
button then operate the selector.

3

Select the play mode.
Press the SURROUND MODE button, then turn the SELECT
knob.

Example: Stereo

(Main unit)

(Remote control unit)

4

Start playback on the selected component.
• For operating instructions, refer to the component’s manual.

5

Adjust the volume.

(Main unit)

(Remote control unit)

The volume level is
displayed on the
master volume level
display.

The volume can be adjusted within the range of –70 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 39, if the volume for any channel is set at +1 dB
or greater, the volume cannot be adjusted up to 18 dB. (In this case
the maximum volume is adjusted to “18 dB — (Maximum value of
channel level)”.)

Input mode when playing DTS sources
• Noise will be output if DTS-compatible CDs or LDs are played in the

“ANALOG” or “PCM” mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL)
and set the input mode to “DTS”.

Input mode display

ANALOG

DIGITAL

DIGITAL

DIGITAL

ANALOG

AUTO

PCM

DTS

INPUT

AUTO

PCM

DTS

INPUT

AUTO

PCM

DTS

INPUT

AUTO

PCM

DTS

INPUT

• In the AUTO mode

• In the DIGITAL PCM mode

• In the DIGITAL DTS mode

• In the ANALOG mode

One of these lights, depending on
the input signal.

Input signal display

SIGNAL

DIGITAL

DIGITAL

DIGITAL

SIGNAL

SIGNAL

• DOLBY DIGITAL

• DTS

• PCM

The

indicator lights when digital signals are being input

properly. If the

indicator does not light, check whether

the digital input component setup (page 26) and connections are

correct and whether the component’s power is turned on.

DIGITAL

DIGITAL

NOTE:
• The

indicator will light when playing CD-ROMs

containing data other than audio signals, but no sound will be
heard.

DIGITAL

After starting playback

[1] Adjusting the sound quality (tone)

1

The tone switches as follows each time the TONE CONTROL
button is pressed.

BASS

TREBLE

2

With the name of the volume to be
adjusted selected, turn the SELECT
knob to adjust the level.

3

2

1

(Main unit)

(Main unit)

3

If you do not want the bass and treble to be adjusted, turn on
the tone defeat mode.

The signals do not pass through the
bass and treble adjustment circuits,
so it provides higher quality sound.

(Main unit)

(Main unit)

ENGLISH