Portable Winch Gas-powered portable capstan winch PCW3000 User Manual

Page 9

3.3.2 Using the hitch plate winch anchor (PCA-1261) for tow balls up to 50 mm (2'')
diameter

1) Figure 1: Push the safety hooks in the rectangular openings of the hitch plate. The rubber

plate must be under the winch;

2) Figure 2: Start the winch engine;
3) Figure 3: Slide the plate on the ball hitch and pull the winch forward;
4) Figure 4: Wrap the rope around the drum and start winching. The winch will align itself

automatically with the load.

USE THE HITCH PLATE ONLY WITH CATEGORY II BALL HITCH (1500

KG (3300 LB)) OR HIGHER. MAKE SURE THE ANCHOR

ING VEHICLE’S HAND BRAKE IS ON

AND WORKING PROPERLY. POSITION BLOCKS BEHIND THE WHEELS TO PREVENT
ROLL BACK.

3.3.3 Using the winch support plate (PCA-1268) with square tubing 50 mm (2'') (PCA-1267)

1) Figure 1, no. 1: Slide the square tubing (PCA-1267) into the vehicle

’s receiver and secure

it with both the hitch

pin and the ‘’R’’ pin;

2) Figure 1, no. 2: Slide the winch support plate (PCA-1268) onto the square tubing and

ecure it with both the hitch pin and the ‘’R’’ pin;

Note: Its lateral movement can be adjusted by positioning the bolts into the square holes;

3) Figure 2: Attach the winch anchor hooks to the eye bolts;
4) Figure 2: Wrap the rope around the drum and start winching. The winch will align itself

automatically with the load.