Pitney Bowes OfficeRight DF100 Desktop Folder - Manual (Page 3)

OfficeRight TM Desktop Letter Folder DF100
Page 3
Normal Operation
1. Insert the power connector into the receptacle on the right hand
side of the paper folder (see figure below). Plug the other end of
the power connector into an appropriate wall outlet. NOTE: The
paper folder does not have an ON-OFF switch, so your folder is
active immediately after the power connector is plugged in.
2. Insert up to three sheets of paper approximately 1 1/2" into the rear
slot. Hold paper so that it lies squarely in the nip (pinch point) of the
rollers underneath. There will be a brief time delay, then the folder
will automatically pull the paper in. Once the folding starts, the paper
should be released. NOTE: For accurate folds, hold your document
very lightly at the top center of the sheets, as shown below. This will
allow the paper to square itself on the folding rollers.
3. Remove the folded paper from the front slot.
Power Connector
Goes Here
Connect to
Wall Outlet