ParkZone PKZU1280 - Manual (Page 11)

11 EN
The CG location is 60mm back from the leading
edge of the center of the wing.
This CG location has been determined with the
included 1S 30mAh 3.7V Li-Po battery installed in
the battery holder.
Balance the model on the edge of a metal ruler to
fi nd the Center of Gravity. Place the ruler on the
underside side of the airframe.
Adjusting Center of Gravity (CG)
60mm
Control Rates
We recommend using a DSM2/DSMX aircraft
transmitter capable of dual rates. Adjust according
to individual preferences after initial fl ight.
It is normal for linear servos to make noise. Noise is
not an indication of a faulty servo.
To achieve the proper Low Rate settings when
using a programmable DSM aircraft transmitter,
set the low rate value to 70% for elevator and
rudder.
High Rate Low Rate
Elevator 100% 70%
Rudder 100% 70%