ParkZone PKZ7080 - Manual (Page 9)

16 17
1. Locate the included wing mounting screw.
2. Turn over the fuselage so you are looking at the bottom. Do the same with the wing.
3. Connect the aileron leads to the preinstalled Y-harness, noting proper orientation. Route the Y-harness
lead through the access hole in the bottom of the fuselage.
4. Carefully align the two locator pins on the rear of the wing into the two small holes in the rear
of the fuselage.
Attaching the Wing 5. Slide the aileron leads inside the fuselage so that they will not become pinched in between
the wing and the fuselage when securing the wing. When the wing is seated, install the wing
mounting screw.
6. Tighten wing mounting screw securely. Make sure there are no gaps between the wing and fuselage
and that the aileron servo leads are not pinched between the wing and fuselage.
The wing is correctly installed when no gap exists between the wing and fuselage.