General assembly, Installing the receiver battery selection – ParkZone PKZ7080 User Manual

Page 8

1. Install your full range receiver in the location shown in the photo using hook and loop tape or

double-sided servo tape.

2. Plug the elevator and rudder Y-harness into the appropriate ports of the receiver. Plug the Y-harness

into the aileron channel of the receiver, and plug the ESC lead into the throttle channel.

When selecting a battery for your Habu we recommend the E-Flite 3200mAh 30C 4-cell battery

(EFLB32004S30) or the Thunder Power 3300mAh 30C 4-cell battery (THP33004SP30).
If using a battery other than those recommended above, it must be able to handle 60-amps

continuously . It should also be roughly the same capacity, dimensions, and weight as the previously

mentioned batteries to allow the battery to physically fit into the airframe and not drastically shift the center

of gravity.

Installing the Receiver

Battery Selection:

General Assembly

This manual is related to the following products:

PKZ7075