ParkZone PKZ7080 - Manual (Page 10)

18 19
1. Locate the following: horizontal stabilizer, rudder, two plastic fin mount plates, 7x larger self-tapping
screws, the tailcone and the tape for securing the tailcone.
2. Plug the elevator and rudder servo leads into the connectors in the fuselage and tuck the elevator and
rudder leads into the horizontal stabilizer.
3. Place the horizontal stabilizer on the fuselage making sure it is resting on the fuselage without
any gaps.
Attaching the Tail 3. Screw the horizontal stab onto the fuselage using two of the self-tapping screws.
4. Remove the rudder pushrod and set aside. Slide fin and rudder into the fuselage.
5. Attach plastic fin mount plates on each side of the rudder making sure the fin mount plates are
aligned with the holes on the fuselage and rudder.