Desa Wall Mantel with Base and Trim WD26CP - Manual

www.desatech.com
Important: Read entire instruction sheet before as-
sembling or installing mantel kit.
This mantel is only approved for use with CDCF, CGCF,
EFS, FDCF, HDCF, VDCF and VMH Series fireplaces. Do
not use mantel with any other product.
This mantel kit contains the following pieces:
• Hardware package
117197-03
• Trim kit GAB6094
• Trim kit hardware 102866-01
The hardware package contains the following:
• 2 - 3" screws
• 20 - 1
1 ⁄
4
" screws
Tools and items required:
• #2 Phillips screw driver (regular length)
• Slotted screw driver
• Measuring tape
• PENCIL
If any wood pieces are missing or damaged, contact the
dealer where you purchased this mantel for replacement.
If hardware is missing or damaged, contact DESA Heating
Products at 1-866-672-6040 for referral and warranty infor-
mation. You can also visit DESA Heating Products' technical
service web site at www.desatech.com.
Note: Place all mantel pieces together before actually as-
sembling mantel.
WARNING: Only use 1 1 /
4
" screws to assemble
header and top. Damage to the mantel will result if the
longer screws provided are used for this purpose.
WS26CP and WD26CP
Wall Mantel with Base and Trim
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Firebox
Perimeter
Trim Included
With This
Mantel