Installing lower wing, Before flight – ParkZone PKZ5580 User Manual
Page 6

EN
Installing Lower Wing
1. Turn aircraft over so the bottom of fuselage faces up.
2. Put the wing’s guide pins in fuselage slot.
3. Put aileron connectors in hole in fuselage.
4. Connect left and right aileron connectors to the
Y-harness in fuselage. There is no difference between
the two connections on the Y-harness. Left and right
servo connectors do not have to be connected to a
particular side of the Y-harness.
5. Align and attach wing to fuselage using two screws.
CAUTION: Do NOT crush or otherwise damage
wiring when attaching wing to fuselage.
6. When needed, disassemble in reverse order.
1
2
3
• Lower throttle and
throttle trim to
lowest settings.
• Connect battery
to ESC.
Continuous LED
Series of tones
Power on
Transmitter
Wait 5
seconds
Before Flight
3 X 10mm (2)
6
Installing a Receiver
Battery Selection and Installation
1. Before installing wing, install your park fl yer or full range receiver in the
fuselage using hook and loop tape or double-sided servo tape.
2. Connect the elevator and rudder servo connectors to the appropriate chan-
nels of the receiver.
3. Connect the aileron Y-harness to the aileron channel of the receiver.
4. Connect the ESC connector to the throttle channel of the receiver.
1. We recommend the ParkZone 1800mAh 11.1V Li-Po battery (PKZ1031).
2. If using another battery, the battery must be at least a 1800mAh battery.
3. Your battery should be approximately the same capacity, dimensions and
weight as the ParkZone Li-Po battery to fi t in the fuselage without changing
the center of gravity a large amount.