ParkZone PKZ4475 - Manual (Page 6)

EN
1. Remove the canopy from the fuselage.
2. Turn the wing and fuselage so their bottom sides
face up.
3. Place the wing’s aileron servo connectors (A) into the
rectangular hole in the fuselage.
4. Slide the two guide pins (B) of the wing into the two
holes in the fuselage.
5. Align and attach the wing to the fuselage using
a screw (C).
6. Inside the fuselage, connect both aileron servo
connectors to the aileron Y-harness. There is no
difference between the two connections on a Y-
harness. Left and right servo connectors do not have
to be connected to a particular side of a Y-harness.
7. When needed, disassemble in reverse order.
CAUTION: DO NOT crush or otherwise damage
wiring when attaching the wing to the fuselage.
NOTICE: Use of CA (cyanocrylate adhesive) accelerant on
your model can damage paint. DO NOT handle the model
until the accelerant fully dries.
1 2 3
• Lower throttle and
throttle trim to
lowest settings.
• Connect battery
to ESC.
Continuous LED
Series of tones
Power on
Transmitter
Wait 5
seconds
Before Flight
Installing the Wing
3 X 25mm
C
B A
6
Installing a Receiver
Battery Selection and Installation
1. Remove the wing to install a receiver.
2. Install your parkfl yer or full-range receiver in the fuselage using hook and
loop tape or double-sided servo tape.
3. Attach the elevator and rudder servo connectors to the appropriate chan-
nels of the receiver.
4. Attach the aileron Y-harness to the aileron channel of the receiver.
5. Attach the ESC connector to the throttle channel of the receiver.
1. The required battery is a 1800–2200mAh 11.1V Li-Po battery. We recom-
mend the ParkZone ® 1800mAh (PKZ1031) or the 2200mAh (PKZ1029).
2. If using another battery, the battery must be at least a 1800–2200 mAh
battery.
3. Your battery should be approximately the same capacity, dimensions and
weight as the ParkZone Li-Po battery to fi t in the fuselage without changing
the center of gravity.