ParkZone PKZ3380 - Manual (Page 3)

5 6
Warning
Though your ParkZone ® Vapor comes ready to fly, this aircraft is for
experienced RC pilots only and is not a toy. It can cause serious
bodily harm and damage to property!
FCC Statement
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Caution!
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
Instructions for Disposal of WEEE by Users in the
European Union
This product must not be disposed of with other waste.
Instead, it is the user’s responsibility to dispose of their
waste equipment by handing it over to a designated
collections point for the recycling of waste electrical and
electronic equipment. The separate collection and recycling of your
waste equipment at the time of disposal will help to conserve natural
resources and ensure that it is recycled in a manner that protects
human health and the environment. For more information about where
you can drop off your waste equipment for recycling, please contact
your local city office, your household waste disposal service or where
you purchased the product.
This product contains a radio transmitter with wireless technology
which has been tested and found to be compliant with the applicable
regulations governing a radio transmitter in the 2.400 GHz to
2.4835 GHz frequency range.
The associated regulatory agencies of the following countries
recognize the noted certifications for this product as authorized for
sale and use:
USA
Canada Belgium
Denmark France Finland
Germany Italy Netherlands
Spain Sweden UK
Step 1
Receiver
Your ParkZone Vapor comes with a fully proportional 3-channel
reciever ready to bind to the DSM2 transmitter of your choice.
Binding Process
The 2.4GHz DSM2 receiver in the Vapor uses a unique binding
operation to link your transmitter with your receiver. Please refer to
your transmitter’s manual for detailed binding instructions. Confirm
that ATV travels are not exceeding 100% prior to binding your
transmitter to the Vapor.
1. Confirm the process of entering the bind mode for your
chosen transmitter by reviewing the instruction manual included
with the transmitter.
2. Make sure the flight battery is fully charged.
3. Confirm the flight battery is disconnected from the receiver/ESC
unit and the transmitter is turned off.
4. Plug the flight battery into the receiver/ESC unit. After 5
seconds the LED on the receiver/ESC unit will begin flashing.
5. After verifying the LED is flashing on the receiver/ESC unit,
follow the steps that allow your chosen transmitter to enter bind
mode.