ParkZone PKZ2200 - Manual (Page 7)

EN
Tip: Turn the clevis clockwise or counterclockwise on the linkage.
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis and put the clevis pin in a selected
hole in the control horn.
• Move the tube to hold the clevis on the control horn.
After binding a transmitter to model receiver, set trims and
sub-trims to 0, then adjust clevises to center control surfaces.
1. 4.
5.
6.
2.
3.
Fly the model at factory settings before making changes. For pilots who
wish to fly model for advanced aerobatics, adjust position of linkages
on control horns for increased travel.
Rudders Ailerons
Arms
Horns
Rudders Ailerons
Arms
Horns
Ailerons
Arms
Elevators
Horns
Ailerons Elevators
Installing Clevises on Control Horns and Control Centering
Factory Settings
Control Direction Test
CAUTION: Keep your hands, loose clothing,
hair and any other item clear of the propeller before
starting the control test in the event that you
accidentally turn on the motor.
CAUTION: Always disconnect the
battery before powering off the transmitter.
Left Aileron (using Aileron stick)
Right Aileron (using Aileron stick)
Down Elevator
Up Elevator
Mode 2 Mode 1
7