OPTI-UPS SS30K33 - Manual (Page 11)

- 11-
unit. It is normal for commutators to become black due to carbon brush tracking. If a
commutator is to be cleaned,use denatured alcohol and a soft cloth.
-Inspect the variable transformer drive belts, sprockets, gears, cams, etc. for signs of slippage
or wear and adjust as required.
-Check the variable transformer radiator(s) (the die cast part that holds the brush assembly) for
signs of slippage, and see if all brushes driven by the same motor are aligned with each other.
The alignment of the radiator and brushes depends on the setscrews that hold the variable
transformer center tube(s) to the shaft and the setscrews that hold the radiator to the center
tube. Adjust and tighten as needed.
-Lubrication of the AVR is not required since it has been lubricated at the factory for its lifetime.
10- Trouble shooting Guide
If any errors of faults are observed on the AVR, make sure you check the following
points before informing the authorized technical service:
• Does the distribution panel have mains connection?
• Have the protection fuses blown off?
Informing the authorized service about the AVR:
• Information found on the product label (model, no)
• Describe the problem in detail.
11. Storage
The unit has to be stored in a dry place between 0℃ ~ 90℃.