Dimplex Electric Fireplace DFG253A - Manual (Page 12)

12 www.dimplex.com
Operation
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DImPLEX
(1-888-346-7539).
Remote Operation
The fireplace is supplied with an
integrated on/off remote control
(Figure 7)
the hand held transmitter.
②
Install one (1) 12-volt (A23)
battery in the battery holder.
③
Close the battery cover.
battery must be recycled
or disposed of properly.
Check with your Local
Authority or retailer for recycling
advice in your area.
Remote Initialization/
Reprogramming
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
re-initialize the remote control and
the remote control receiver in the
fireplace:
①
Place the Three Position
switch (Figure 6A) in the off
(“ O ”) position.
②
Wait a minimum of five (5)
seconds and then place the Three
Position on/off switch in the
remote (“ II ”) position.
③
Within 10 seconds of
changing the switch position,
press the on button located on
the remote control (Figure 7).
Figure 7
Off
button
On
button
battery
battery
Cover
! NOTE: Ensure that the
fireplace's Three Position
switch is set to the remote
control (“ II ”) setting
(Figure 6A).
To operate, push the on button
to turn fireplace on, push the oFF
button to turn the fireplace off.
Battery Replacement (Figure 7)
To replace the battery:
①
slide battery cover open on