Dakota Digital 3 - Manual (Page 6)

MAN 650066:E 6
MESSAGE DISPLAYS
On systems with two message displays, Switch 1(SW1) will toggle between the speed
message displays and Switch 2(SW2) will toggle between the tach message displays.
On systems with one message display, SW1 will either switch from the tach message to
the speed message and then toggle to the next speed message with each press and release.
SW2 will switch from the speed message to the tach message and then toggle to the next tach
message with each press and release.
Speed message displays DESCRIPTION .
ODOMTR odometer reading (0-999,999)
TRIP A trip A odometer reading (0-9999.9)
TRIP B trip B odometer reading (0-9999.9)
SERVIC (when enabled)
reading since last service (0-9,999, or ---- when past due)
0-60 T 0-60 mph time in seconds (0-25.5)
HI SPD high speed recall (0-255)
QUARTR ¼ mile time in seconds (0-25.5)
QT SPD ¼ mile trap speed (0-255)
KPH xxx kph conversion (or mph conversion if kph selected as primary unit)
NOTE: In normal operation you have to use Switch 1 (SW1) to reset trip meters, service
counter, and the various performance timers. A press and hold will zero the current
reading, if it can be reset.
Tach Message displays DESCRIPTION
.
HI RPM high rpm recall (0-18,000)
HOURS hours system has been on with tach signal (0-999.9)
BAR (on systems with no bar graph) bar tach readout on message display (0-8)
RPM (on systems with no digital tach) digital tach readout on message display
TACH (on systems with no digital tach) digital tach readout on speed display
ENGINE check
engine indicator
BRAKE brake warning indicator
4W DRV 4 wheel drive indication
WAIT diesel wait to start indicator
GEAR( with optional GSS-2000) gear shift position indicator
BIM modules BIM messages will display on tach message display
NOTE: In normal operation you have to use Switch 2 (SW2) to reset hour meter and high
RPM recall. A press and hold will zero the current reading, if resettable. A press and
hold will also clear warning messages such as ENGINE, BRAKE, etc.