Mighty Mule FM500 Green Board - Manual (Page 36)

32
Step 3
With the gate in the desired open position PRESS & HOLD the “SET LIMIT" button on the control board for 5 seconds.
Step 4
Press the transmitter button and allow the gate to return to the
closed position. YOUR GATE’S OPEN POSITION LIMIT IS
NOW PROGRAMMED.
TESTING YOUR OPEN LIMIT SETTING:
Press your entry transmitter and allow your gate to open. If the
OPEN position is not correct or need to be changed, you will
need to CLEAR your OPEN LIMIT settings and follow steps
one (1) to four (4) again.
CLEARING PROGRAMMED OPEN LIMIT
SETTING:
If you make a mistake and set the limit at the wrong position
– press your transmitter to return the gate to the fully closed
position, then press and hold the "SET LIMIT" button for 10
seconds. This will clear the memory for the open limit position.
Follow steps one (1) to four (4) again.
1 ON
2
3
4
5
6
7 RECEIVER
SET
LIMIT
LEARN
TRANSMIT
TER
MODES
ON OFF
1
2
3
4
5
6
7
COM
CYCLE
CLOSE
SAFETY
EXIT/
OPEN
SHADOW
LOOP
CLOSE
EDGE
OPEN
EDGE
BLK
GRN
RED
Set Limit Button
ST
ALL FORCE
MIN
MAX