Martin Archery Martin Compound - Manual (Page 9)

Fury XT Single Cam
The Martin Fury XT Single Cam features a rotating module for draw length
adjustments in half-inch increments. The cam also allows the draw weight to be
lowered up to #20 pounds by moving the split cable to various weight adjustment posts.
Parts Of The Martin Fury XT Single Cam
Speed Bearing
Module
Screws
Bottom Cam
Idler Wheel
Fury XT Single Cam String Diagram
The string harness on your Fury Cam is installed according to the diagram below. Your
string harness should be installed by your qualified Martin dealer.
Module
Draw
Stop
Weight Adjustment Posts Speed Bearing
Shooting
String
2nd half
Shooting
String
Split/Buss
Cable
Module Setting Mark
Adjusting The Fury XT Single Cam Draw Length
Make a note of the number on the Module by the setting mark. To rotate the draw length
module, you will first need to remove the two (2) allen head module screws. Lift and rotate the
module to the desired position and replace and tighten the screws in the appropriate
positions. Larger numbers on the Module will increase draw length and smaller numbers
will decrease your draw length.
DO NOT draw the bow without the draw length module in place and secured.
Adjusting The Fury XT Single Cam Draw Weight
The Fury XT Single Cams has two additional weight adjustment posts besides the standard
setting post. Moving the split cable to these posts will lower your draw weight by #10 or #20.
This process requires a bow press so visit your qualified Martin dealer.
9