Delta 3 H.P. SINGLE-STAGE DUST COLLECTOR 50-853 - Manual (Page 13)

13
OPERATING CONTROLS
ON/OFF SWITCH
(Model 50-852)
The “on/off” switch is located on the side of the motor
stand. To turn the dust collector “ON”, push button (A)
Fig. 36. To turn the dust collector “OFF”, push button
(B).
Fig. 36
Fig. 37
ON/OFF SWITCH
(Model 50-853)
The “on/off” switch is located on the side of the motor
stand. To turn the dust collector “ON”, push button (A)
Fig. 37. To turn the dust collector “OFF”, push button
(B).
MAINTENANCE
WARNING: Before any maintenance or service is performed, be sure that unit is disconnected from power source
to prevent accidental starting.
MOTOR MAINTENANCE
Removing dust and dirt: Blow off motor with low pressure air to remove dust or dirt. Air pressure above 50 P.S.I. should
not be used, as high pressure may damage insulation and blow dirt under loosened tape. The operator performing this
cleaning function should always wear appropriate eye protective goggles. Built-up dust can cause excessive insulation
temperatures, thereby affecting motor life.
A
B
A
B